Publicidad
ASSEMBLY INSTRUCTIONS FOR BUILT-IN WASHING MA-
CHINES
IMPORTANT - This machine complies with current safety regulations govern-
ing electrical appliances and, to ensure user safety, it must be installed by a
qualified technician as required by current legislation
Size of cabinet
Applying the
panel
Using the tem-
plate
The minimum dimensions of the cabinet are: height 820 mm,
width 600 mm, depth 584 mm (fig. 1).
The panel may be attached to the left- or right-hand side of the
washing machine (fig. 2)
The machine is supplied fitted for a left-hand side panel at-
tachment as the right-hand side is fitted with the push-pull lock
(upper part) and the rubber pad (lower part).
Should you wish to use the magnetic lock instead of the push-
pull lock, remove the push-pull lock support and fit the supplied
magnetic lock support.
Important! Before fitting the panel (removing all the hinge
and locking elements from the front) make sure the wash-
ing machine is totally disconnected from the mains power
supply.
Warning - To fix the panel on the right-hand side (direction of
opening opposite to that of the door) dismount the push-pull
lock (or the magnet lock) from the front of the machine and the
rubber pad (fig. 3-A) and fit them on the opposite side (fig. 3-
B).
All the elements applied to the front of the washing machine
must be remounted correctly (no holes must remain open) in
order to make it impossible to touch live components inside the
machine.
Our company declines all liability for failure to observe the
above safety requirement.
1) Measure the height of the kitchen baseboard: the height of
the wooden panel is obtained by first establishing the height
of the kitchen baseboard.
E.g.: for a 100 mm high baseboard, the maximum height of
the panel is 720 mm. If the height of the baseboard must be
increased, the height of the wooden panel must be reduced.
4
Publicidad
