Publicidad
cause permanent injury to the eyes, mouth, and throat, or even cause death
by suffocation.
The appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concern-
ing use of the appliance by a person responsible for their safety.
Do not store flammable fluids near the appliance.
Length periods out of use.
If the appliance is not to be used for a lengthy period it should be discon-
nected from the electricity and water supplies and the door should be left
ajar to prevent unpleasant smells from building up inside.
For Great Britain only
WARNING: this appliance must be earthed.
Fuse replacement
If the mains lead of this appliance is fit-
ted with a BS 1363A 13amp fused
plug, to change a fuse in this type of
plug use an A.S.T.A. approved fuse to
BS 1362 type and proceed as follows:
1. Remove the fuse cover (A) and
fuse (B)
2. Fit replacement 13A fuse into
fuse cover
3. Refit both into plug
Important:
The fuse cover must be refitted when changing a fuse and if the fuse cover is
lost the plug must not be used until a correct replacement is fitted.
Correct replacement is identified by the colour insert or the colour embossed in
words on the base of the plug.
Replacement fuse covers are available from your local electrical store.
If the appliance is provided with a plug less supply cord:
It is necessary to install in the fixed wiring an all-pole disconnection de-
vice having a gap between contacts of at least 3,5mm. After installation
the disconnection device must be easy to reach.
The connection to the mains must be carried out by a qualified technician
in accordance to the scheme shown below and the regulations in force
In the event of damage to the supply cord, it must be replaced by the
manufacturer or an authorized technical service centre to avoid any risk.
EN
L = brown
N = blue
= yellow-green
5
Publicidad
