Publicidad
Idiomas disponibles
Idiomas disponibles
1. Introduction
The control unit BAX900 is a control unit developed to control rolling shutters in an easy and intuitive way. This product controls motors up to 230
Vac up to 1000W. It is equipped with a courtesy light output. The product is compliant with transmitters B.ro with 2 or 3 buttons. It is equipped with
a photocells output.
WARNING : DO NOT INSTALL THE CONTROL UNIT WITHOUT READING THE INSTRUCTIONS FIRST !!!
2. Setting
Signalling
led
3. Electrical connections
The control unit is supplied with all the inputs normally closed and jumpered to the common.
Before connecting a device to the control unit remove the jumper corresponding to the device that you want to connect leaving the others
unchanged.
1
2
6-1622606
rev.0
10/05/2013
Control unit BAX900
Programmable control unit for rolling shutters
Connect the power supply cable between the
clamps 10 and 11 of the control unit.
Connect an eventual courtesy light between
the clamps 12 and 13 of the control unit.
ITA
ENG
Power supply 230 Vac 50Hz
Do not connect the card directly to the electric net-
work. Put a device which can ensure the disconnec-
tion of each pole from the power supply of the control
unit.
Connecting a charge of 230Vac 500W MAX it is
possible to light up the operating zone of the auto-
mation during each motion. The turning off is timed
with a period of 3 minutes. The counting is reset at
each impulse of up or down.
FRA
ESP
DEU
POR
2 / 8
Publicidad
