Agri-Fab 45-0522 Manual Del Usuario página 9

9. Fit the ends of the two upper hopper tubes into the ends
of a rear hopper tube. Align the holes in the ends of the
tubes and secure them in place using two 1/4" x 1-1/8"
clevis pins and small hairpin cotters.
SMALL HAIRPIN COTTER (M)
FIGURE 5
10. Fit the ends of the two lower hopper tubes into the ends
of a rear hopper tube. Align the holes in the ends of the
tubes and secure them in place using two 1/4" x 1-1/8"
clevis pins and small hairpin cotters.
FIGURE 6
1/4" x 1-1/8" CLEVIS PIN (J)
SMALL HAIRPIN COTTER (M)
1/4" x 1-1/8" CLEVIS PIN (J)
11. Unfold the hopper bag and lay the bag out with the
wind screen on top.
12. Place the assembled lower hopper tubes into the
bottom of the hopper bag and then slide the tubes to
the back of the bag.
FIGURE 7
13. Insert the ends of the assembled upper hopper tubes
down through the stitched sleeves in the sides of the
hopper bag.
FIGURE 8
9
STITCHED SLEEVE