Operation; Clamping Force Adjustment And Workpiece Clamping - Hoffmann GARANT HiPo Clamp Manual De Instrucciones

6.

Operation

Only use cooling agents with anti-corrosive properties.
DE
6.1

Clamping force adjustment and workpiece clamping

EN
The clamping force is set by turning the lock ring
(1) up to the marking (orange) on the sleeve.
FR
▶
▶
▶
IT
Max. crank torque of 40 Nm must not be exceeded
→ otherwise there is a risk of damage!
▶
▶
ES
▶
▶
22
1
Compact, rigid workpieces, heavy machining
→ max. clamping force.
Workpieces at risk of deformation, light machining
→ reduced clamping force.
At lock position "0" (= direct clamping), the power transmission is
not active. This setting must only be used for low-force clamping, or to
pre-clamp "rebounding" workpieces.
Clamping is only permitted through
CLOCKWISE rotation of the crank.
No INTERNAL CLAMPING.
Do not continue rotating the crank
by force.
Do not strike the crank.
Adjustment: (for rigid workpieces)
Clamping force (kN)
Jaw width 125
Direct
5 kN
10 kN
15 kN
20 kN
25 kN
30 kN
35 kN
40 kN
Jaw width 160
Direct
07.5 kN
15 kN
22.5 kN
30 kN
37.5 kN
45 kN
52.5 kN
60 kN