ETI Solid State Lighting 514032110 Manual De Uso Y Cuidado página 2

Adjusting the sensitivity of the motion sensor:
13
• Turn the sensitivity knob to adjust the sensitivity (5ft. to 60ft.).
• The motion sensor is more sensitive to movement across its coverage area.
NOTE: The higher sensitivity level increases the likelihood of a false
activation being triggered.
Dual brightness mode (50% brightness)
15
• OFF : turn off the dual brightness mode
• 3 hrs & 5 hrs : the brightness will fall back to 50% after detection
for 3 hrs or 5hrs
• Dusk to dawn : the brightness will fall back to 50% after detection
until dawn
WARNING: Carefully read and understand the information given in this manual before beginning the assembly and installation. Failure to do so could lead to electric shock, fire, or
other injuries which could be hazardous or even fatal. • Ensure the electricity to the wires you are working on is shut off. Either remove the fuse or turn off the circuit breaker.
NOTICE: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna, increase the separation between the equipment and the receiver, connect the equipment into an outlet on a circuit different from that to which
the receiver is connected, and consult the dealer or an experienced radio/TV.
• Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
See website for Warranty, Troubleshooting or Care and Cleaning details at www.ETiSSL.com.
Questions, problems, missing parts? Call ETiSSL Customer Service 8 a.m. - 5 p.m., CST, Monday - Friday
U.S.A. Patent 10091855
1-855-ETI-SSLI (1-855-384-7754) www.ETiSSL.com
Move the timer knob to the desired timer setting (1 to 10 minutes).
14
The timer setting indicates how long the light stays on after motion is detected.
Maintenance - Replacing the photocell:
16
• Shut off the power at the circuit breaker or fuse panel.
• Remove the rubber plug and long mounting screw to remove
the fixture.
• Unscrew the two wire connectors to disconnect the photocell.
• Replace with a new photocell.
• Reconnect the wires and wire connectors and reattach the
fixture.