Greencut JET140C-4 Manual De Instrucciones página 46

46
HIGH PRESSURE HOSE
1. Make sure that the ON/OFF switch is in the OFF position.
2. Tighten the high pressure hose to the gun (3).
But do not over-tighten.
3. Insert the adjustable spray lance into the spray
gun (3), and turn it 1/4 turn until the rectangular
tab appears. Then insert the nozzle (Fig. J).
4. First remove the protective
cap (b) from the outlet, then
connect the pressure hose to
the machine outlet (7), making
sure it is firmly connected (Fig.
K, L).
HIGH PRESSURE HOSE
1. Connect the water pipe with the 1/2 HPC connector to the inlet
of the inlet filter (Fig. M).
PRODUCT USE
IGNITION
1. Connect the plug to a suitable outlet.
2. The trigger switch is in the locked position to prevent accidental starting.
3. Push the safety lock to the unlocked position (Fig. N).
4. Before operating the high pressure cleaner, press the trigger switch to bleed air trapped in the pump and
hose (Fig. O).
5. Start the pressure washer by turning the ON/OFF switch to the ON position (Fig. P). Press the trigger.
NOTE: The engine only runs when the trigger is pulled.
N
J
K
O
L
M
P