Greencut JET140C-4 Manual De Instrucciones página 48

48
TROUBLESHOOTING
The table includes some of the most common problems, their causes and remedies
PROBLEM
Machine is not plugged in.
Machine does
Faulty plug.
not start
Extension cable defective.
Pump sucks air.
Fluctuating
Pump seals worn.
pressure
Outlet nozzle is not smooth.
Incorrect mains voltage.
Machine stops
Thermal cut-off activated.
Nozzle partially blocked.
Air in inlet hose.
Inadequate mains water supply.
Machine
vibrates
Nozzle partially blocked.
Water filter blocked.
Hose kinked.
Machine often
starts and Pump/spray gun leaking.
stops by itself
Pump/spray gun or attachment is frozen.
Machine starts
up, but no
No water supply.
water comes
Water filter blocked.
out
Blocked nozzle.
NOTE: In the event of not being able to resolve the problem, get in touch with an Authorised
Service Centre.
POSSIBLE CAUSE SOLUTION
Plug in the machine.
Try a different socket.
Try without the extension cable.
Check hoses and connections for leaks.
Clean and replace.
Clean and replace.
Check that the mains voltage corresponds to
the voltage specified on the model label.
Let the machine cool down for 5 minutes.
Clean the nozzle.
Let the machine run with the trigger open
until normal working pressure is restored.
Check that the water supply corresponds to
the required specifications.
Avoid using long, thin hoses (min. 1/2").
Clean the nozzle.
Clean the filter.
Straighten the hose.
Contact the nearest service centre.
Wait for pump/hoses or fitting to thaw.
Connect the water supply and switch it on.
Clean filter.
Clean the nozzle.