Medisana 51139 Instrucciones De Manejo página 24

51139_MTC_West_aktual.qxd:Blutdruckmessgerät
GB
3 Getting Started
3.2
Using a mains
adaptor
3.3
Setting time
and date
3.4
Adjusting the
voice function
18
Alternatively, the unit may also be operated with a special power adapter
(MEDISANA item no. 51125), which is plugged into the connector
on the right-hand side of the unit. In this case the batteries remain in the unit.
The batteries are disconnected mechanically when the connector is inserted on
the right-hand side of the blood pressure monitor. It is necessary, therefore, to
plug the mains adaptor into the mains socket first of all and then to connect it
to the blood pressure monitor. If the blood pressure monitor is no longer being
used, first remove the connector from the blood pressure monitor and then pull
the mains adaptor out of the mains socket. Doing this means that the date and
time will not have to be reset each time.
1. The date and time can be set with the device switched off. Press the START
button and the MEM button
the display (flashing). To change the month, press the MEM button
repeatedly until the required value is displayed. The value auto-repeats if
the MEM button is held down. Pressing the START button
displays the values for month, day, hour and minute (flashing). Press the
MEM button to change the values.
2. After the fifth press of the START button
stop flashing. The time setting is now complete.
3. The date and time must be reset if the batteries are replaced.
The voice function can be adjusted with the device switched off, i.e. with just
the date and time displayed. Press and hold down the MEM button
the selected language appears on the display (e.g. L1).
L0 = Language function switched off
L1 = German
L2 = English
L3 = Spanish
L4 = Dutch
L5 = French
L6 = Italian
L7 = Portuguese
The device speaks the language setting, and changes the display and the an-
nouncement to the next language if the MEM button
selected language can be changed by releasing the MEM button
as the language that you require is displayed or spoken. The selected volume,
which is indicated by flashing bars, can be modified by pressing the MEM
button again and holding it down until the required volume is indicated –
the higher the bar, the louder the volume. Release the MEM button
confirm your selection. The bar stops flashing and the display switches back to
the time display.
07.12.2010 12:03 Uhr
simultaneously. The month appears on
the numbers in the display
is held down. The
Seite 18
provided
again
until
as soon
to