GLIDEAWAY Lifestyle Serie Manual De Instrucciones página 16

Assembly - Head Board Bracket
Assembly - Head Board Bracket
If using a head board, perform the steps as follows:
3
3
Attach the head board
Attach the head board Attach the head board
attachment plate (Part C) to the
attachment plate (Part C) attachment plate (Part C)
horizontal shaft (Part B) using
to the horizontal shaft to the horizontal shaft
the two flat head self locking
(Part B) using the two (Part B) using the two
screws (Part E), two washers
at head self locking
(Part G) and two nuts (Part F)
screws (Part E), two
provided with the kit.
washers (Part G) and two washers (Part G) and two
nuts (Part F) provided nuts (Part F) provided
with the kit.
4
Insert, from the outside of the
bed, the horizontal shaft (Part B)
4
into the horizontal fitting of the
Insert, from the outside
bed attachment (Part A).
of the bed, the horizon-
tal shaft (Part B) into
the horizontal tting of
the bed attachment
(Part A).
5
Adjust the position of the
head board attachment
plates (Part C) to the right
5
or the left of the bed as
Adjust the position of the head
desired by moving the
board attachment plates (Part
horizontal shaft (Part B)
C) to the right or the left of the
left and right in the
bed as desired by moving the
horizontal tting of the
horizontal shaft (Part B) left
and right in the horizontal fitting bed attachment (Part A).
of the bed attachment (Part
Once positioned correctly
A). Once positioned correctly
tighten screws (Part D) to
tighten screws (Part D) to hold in
hold in place.
place.
To adjust the position of
To adjust the position of the head board attachment plates (Part C) vertically, loosen
the head board attachment plates (Part C) vertically, loosen nuts and the head board attachment plates (Part C) vertically, loosen nuts and
nuts and screws from step 3. Tighten when the appropriate height for your head
screws from step 3. Tighten when the appropriate height for your head screws from step 3. Tighten when the appropriate height for your head
board is met.
board is met.
Install the head board using the line of 3 oval holes on the outside of the head board
Install the head board using the line of 3 oval holes on the outside of the
attachment plate.
head board attachment plate.
WARNING: The end of the horizontal shaft (Part B) must always extend beyond the
WARNING: The end of the horizontal shaft (Part B) must always extend
end of the horizontal fitting of the bed attachment! (Part A) (See Fig. 5)
beyond the end of the horizontal tting of the bed attachment! (Part A)
(See Fig. 5 Arrow)
Fig. 3 Fig. 3
PART F PART F
PART B PART B
Fig. 4
PART B
PART A
Fig. 5
PART B
PART D
15
PART C PART C
PART G PART G
PART C
PART A
PART E PART E