Publicidad
Idiomas disponibles
Idiomas disponibles
Instruction of the throttle trigger
Start the blade rotation
1.
Grasp the throttle lever.
2.
Move the control lever to high speed side slowly.
3.
Then engine speed increase gradually, and the
blade starts rotation.
4.
Adjust the blade rotational speed by the control
lever.
Note: Engine speed does not increase by
grasping the throttle lever If the control lever
is positioned at low speed side fully.
L:
Low speed
H:
High speed
Blade Rotate
Blade Stop
Stop the blade rotation
1.
The engine speed will down to idling by moving
the control lever to low speed position fully, or
releasing the throttle lever.
2.
If you did not change the control lever position,
engine speed become to the original adjusted
speed when grasp the throttle lever again.
Control Lever
Throttle Lever
— US-16 —
Operation
WARNING
POTENTIAL HAZARD
• Foreign objects can be thrown by the
Edger.
WHAT CAN HAPPEN
• Contact with thrown objects can cause
personal injury.
HOW TO AVOID THE HAZARD
• Never operate the Edger without the
blade shield in place.
• Make sure the blade shield is correctly
positioned to shield operator from
thrown debris.
CAUTION
• Read the Safety instructions on US-7
concerning proper use of the Edger.
Operating Position
Hearing
Protection
Right Arm
Slightly Bent
Hand Holding
Throttle Grip, Fingers
on Throttle Trigger
Direction of Travel
Before using the Edger, check the following:
1.
Make sure the 3 mm hex wrench has been
removed from the gearcase and boss adapter
before you start the engine.
2.
The Edger should be on the operator's right side.
3.
The operator's right hand should be holding the
shaft grip, with his or her fingers on the throttle
trigger. The right arm should be slightly bent.
Eye Protection
Left Arm Fully
Extended, Hand
Holding Loop Handle
Guard Adjusted to Clear
Blade, and Guard Operator
from Thrown Debris
Publicidad
