Zanussi ZFC639WAP Manual De Instrucciones página 17

Problem
There is too much frost and ice. Products are not wrapped properly.
The lid doesn't close completely. There is excessive frost.
The lid is difficult to open.
The lamp does not work.
It is too warm in the freezer.
It is too cold inside the freezer.
The appliance does not work at
all. Neither cooling nor lighting
works.
All manuals and user guides at all-guides.com
Possible cause
The lid is not shut properly or do not
close tightly.
The temperature is not set correctly.
The water drainage plug is not cor-
rectly positioned.
The lid gaskets are dirty or sticky.
Food packages are blocking the lid.
The lid gaskets are dirty or sticky.
The valve is blocked.
The lamp is defective.
The temperature is not set correctly.
The lid does not close tightly or it is
not shut properly.
Before freezing the appliance was not
precooled sufficiently.
Large quantities of food to be frozen
were put in at the same time.
Food placed in the appliance was too
warm.
Products to be frozen are placed too
closely to each other.
The lid has been opened often.
The lid has been opened for a long
time.
The temperature is not set correctly.
Plug is not connected to the mains
socket properly.
Power does not reach the appliance.
The appliance is not switched on.
Solution
Wrap the products better.
Check if the lid closes well and the gas-
kets are undamaged and clean.
Set a warmer temperature.
Position the water drainage plug in the
correct way.
Eliminate excess frost.
Clean the lid gaskets.
Arrange the packages in the right way,
see the sticker in the appliance.
Clean the lid gaskets.
Check the valve.
Refer to "Replacing the lamp".
Set a lower temperature.
Check if the lid closes well and the gas-
ket is undamaged and clean.
Pre-cool the appliance for enough time.
Wait some hours and then check the
temperature again. Next time insert
smaller quantities of food to be frozen at
any one time.
Allow food to cool to room temperature
before storing.
Place the products in a way so that cold
air could circulate among them.
Try to not open the lid often.
Do not leave the lid open longer than
necessary.
Set a warmer temperature.
Connect the mains plug properly.
Try connecting another electrical device
to the power outlet.
Switch on the appliance.
17