Publicidad
Idiomas disponibles
Idiomas disponibles
English
Charging Indicator LED
1. While charging, the white LEDs on the charger
flash and increase in sections.
2. When charging is completed, the white LEDs will turn off.
Switching On (Fig. D)
1. To switch the appliance ON, press the On/Off switch
2. Press the On/Off switch
1
3. Press the On/Off switch
1
Fig. D
1
State of Charge Indicator (Fig. E)
This appliance includes a state of charge indicator
consists of three white LED lights that indicate the level
of charge remaining in the battery. This feature is only
activated when the vacuum is powered on.
The state of charge indicator is an indication of approximate
levels of charge remaining in the battery pack according to
the following indicators:
The LED battery indicator displays the remaining charge
and warns you when the battery is low. The final LED will
flash continuously when there is only 1 minute of runtime
remaining. All LEDs will flash when the unit is discharged.
nOTE: The state of charge indicator is only an indication
of the charge left on the battery. It does not indicate tool
functionality and is subject to variation based on product
components, temperature and end-user application.
Fig. E
2
Extendable Crevice Tool (Fig. A)
1. To extend the crevice tool
vacuum nozzle
3
until it clicks in place.
2. To collapse the crevice tool
nozzle
3
until it clicks in place.
4
will
9
.
1
again to engage boost mode.
switch to turn the vacuum Off.
that
2
, pull it out from the
4
4
, push it into the vacuum
Attaching Motorized Brush (Fig. F)
CAUTION:
off when the motorized brushis attached or detached.
nOTE: Do not use directly on pets.
1. Slide the vacuum nozzle
motorized brush
10
.
2. Ensure that the plastic retaining tabs
the recesses
16
. An audible click will be heard.
Fig. F
3
16
Removing Motorized Brush
CAUTION:
off when the motorized brush is attached or detached.
1. Pull the the plastic retaining tabs
from the recesses
16
.
2. Pull the vacuum nozzle
3
Dry Pick Up
For everyday spills of dry material.
-
Do not fill the dust bowl
filter.
Optimizing the Suction Force
In order to keep the suction force optimized, the filters must
be cleared regularly during use.
Emptying and Cleaning the Product
Removing the Dust Bowl and Filter (Fig. g, h)
WARNING:
should be cleaned regularly.
1. Hold the dust bowl over a trash can before pressing the
dust bowl release button
access door
18
as shown in Figure G.
2. While holding the dust bowl over a trash can, lightly
shake it to empty the dust bowl
3. Lift the prefilter
out of the dust bowl
19
in Figure H.
4. Lift the filter
20
out of the dust bowl
5. While holding the dust bowl over a trash can, empty the
dust bowl
5
.
6. Install the filter
20
into the dust bowl
the prefilter
into the dust bowl
19
The unit needs to be switched
into the opening of the
3
15
engage with
10
15
The unit needs to be switched
15
outward, away
from the motorized brush
10
5
beyond the end of the
The filter is reusable and
6
to release the dust bowl
.
5
as shown
5
5
.
5
, then install
.
5
.
Publicidad
