Cata I 604 B Instrucciones De Uso página 18

- a magnet-attracting vessel may be a suitable vessel for
induction cooking
- prefer vessels which are especially declared to be suitable
for induction cooking
- flat- and thickbottomed vessels
- a vessel with the same diameter as zones ensures the
maximum exploitation of power
- a smaller vessel reduces power exploitation, but does not
cause any energy loss We would anyhow not recommend
the use of vessels with diameters smaller than 10 cm.
- stainless-steel vessels with multi-layer or ferritic stainless-
steel bottoms when specifically suited for induction cooking
- cast-iron preferably enamel-bottomed vessels to avoid
scratching the pyroceram surface
- we do not recommend the use of any glass, ceramic,
earthenware, alluminium,
(austenitic) stainlesssteel vessels.
Maintenance (Fig. 4)
By means of a scraper immediately remove any alluminium
foil bits, food spills, grease splashes, sugar marks and other
high sugarcontent food from the surface in order to avoid
damaging the hob.
Subsequently clean the surface with some towel and
appropriate product, rinse with water and dry by means of a
clean cloth. Under no circumstance should sponges or
abrasive cloths be used; also avoid using aggressive
chemical detergents such as oven sprays and spot
removers.
Installer's Instructions
Installation
These Instructions are for the qualified technician, as a guide
to installation, adjustment and maintenance, according to
the laws and standards in force. These operations must
always be carried out when the appliance has been
disconnected from the electric system.
Positioning (Fig. 5)
The fixture is especially designed for fitting into a work-top
as shown in the corresponding figure. Place the supplied
sealing agent along the hob perimeter. Do not install the hob
over an oven; in case you do, make sure of the following:
- the oven is equipped with an appropriate cooling system
- there is no warm-air leakage from the oven towards the
hob
- suitable air-inlets are provided as shown in the figure.
(Fig. 5)
1 Front view
2 Front side
3 Oven or cupboard zone
4 Air input
Electrical connection (Fig. 6)
Prior to carrying out the electrical connection, please ensure
that:
the plant charac- teristics are such as to follow what is
indicated on the matrix plate placed at the bottom of the
working area;
copper or non-magnetic
that the plant is fitted with an efficient earth
-
connection, following the standards and law
provisions in force.
The earth connection is compulsory in terms of
-
the law.
Should there be no cable and/or plug on the equipment, use
suitable absorption material for the working temperature as
well, as indicated on the matrix plate. Under no
circumstance must the cable reach a temperature above
50°C of the ambient temperature.
Insert in the fixed wiring a mean for disconnection from the
supply mains having a contact separation in all poles that
provide full disconnection under overvoltage category III
conditions, in accordance with the wiring rules. The plug or
omnipolar switch must be easily reached on the installed
equipment.
This appliance is not intended to be used via an external
timer or a remote control system.
The manufacturers decline any responsibility in the event of
non-compliance with what is described above and the
accident prevention norms not being respected and
followed.
To avoid all risk, if the power cable becomes damaged, it
must only be replaced by the manufacturer, by an
authorised service centre, or by a qualified electrician.