Publicidad
6.2 Setting Mowing Height - Pull Type
1. Park the tractor and mower on level ground.
2. Using the hydraulic cylinder or ratchet attached
to the rear axle position the front skid shoes 1"
less off the ground of the desired mowing height.
(Example: If a 3" cut is desired Place the Skid-
shoes at 2" off the ground.) If a hydraulic cylinder
is used for height control, stroke spacers can be
placed on the cylinder rod to maintain a set cut-
ting height.
2. Adjust the two Leveling Rods so the front of the
mower is approximately 3/4" lower than the rear.
3. Level Rod adjustment is achieved by loosening
the lock nut against the turnbuckle, then rotate
the turnbuckle to achieve the desired setting.
4. Be sure Level rods are equally set to maintain a
level cut.
5. Tighten the lock nut against the turnbuckle to
maintain the setting.
6.3 Setting the Pitch
2310 SERIES 10/19
© 2019 Alamo Group Inc.
OPERATION
Operation Section 4-14
Leveling Rod
Lock Nut
Turnbuckle
Publicidad
