Publicidad
• Cutting performance and distribution are best when cutter is level from side to side and front to rear.
In extra heavy material, rear chains will allow better discharge and better distribution than solid rear
deflectors or bands.
• Never operate the Mower below full PTO speed of 540 or 1000 rpm.
• Corn should be cut at 5 to 6 mph. If full PTO rpm cannot be maintained, use one lower gear.
Operating Noise Level/Sound Pressure
The sound levels at the operator's ear from the attached machine (rotary cutter) are at least 10 dB(A) below
the levels from typical Agricultural tractors used to power and transport this machine. Therefore, the Noise
emission values given by the OEM of the Agricultural tractor used to power and transport this machine would
be valid when this machine is attached to and operated by that Agricultural tractor in all OEM recommended
applications.
In addition to the standard Limited Warranty shown on the facing page, Bush Hog also provides:
1. A FIVE-YEAR (60 months) LIMITED WARRANTY* on GEARBOX components provided they have
been properly maintained† and have not been subjected to abuse or mis-use except as limited below.
* WARRANTY LIMITATIONS - GEARBOX
A. Warranty is ONE-YEAR (12 MONTHS) for Seals (After one year, seals are considered to be
WEARING PARTS and replacement is the users' responsibility.)
B. Users' Gearboxes may be rebuilt by Bush Hog or replaced by new or rebuilt Gearboxes at the option
of Bush Hog.
2. ONE-YEAR (12 months) LIMITED WARRANTY** on the DRIVELINE components provided they have
been properly maintained† and have not been subjected to abuse or mis-use.
* *WARRANTY LIMITATIONS - DRIVELINE
A. Warranty is ONE-YEAR (12 MONTHS) for DRIVELINE SHIELDS except that evidence of wear from
contact with other parts on the shield voids this warranty.
B. Shield Bearings are wearing parts and are not warrantable.
C. Slip-Clutch Disks are wearing parts and are not warrantable. Evidence of "burning up" Slip Clutch
Plates due to improper adjustment will void warranty on Slip Clutch Parts.
† NOTE - "properly maintained" specifically includes, but is not limited to:
A) Running Gearboxes with the proper amount of the correct lubricant.
B) Adjusting Slip Clutches correctly to provide proper protection for Driveline and Gearbox Components.
C) Properly lubricate all driveline components as specified.
D) Maintaining proper bearing preload on all gearbox shafts.
2310 SERIES 10/19
© 2019 Alamo Group Inc.
INTRODUCTION
KEY OPERATION POINTS
Warranty information
Introduction Section 2-5
Publicidad
