Publicidad
3 POINT LIFT MODEL ASSEMBLY
RH Mast
3/4" Locknut
Strut
Bushing
1. Remove the mast from the shipping position and attach the LH and RH Mast to the inside of the inner
mount plates using the rear holes. Install the 2 Strut Bushings in the holes of the Mast. Install using the
5/8" x 2" capscrew, 5/8 SAE flatwasher and 5/8" locknut. Make sure the 5/8" flatwasher is installed to
the inside against the bushing in order to retain it in the mast.
2. Assemble the mast halves by placing the CAT I Quick Hitch Top Bushing between the mast in the lower
hole and install the 3/4" x 4" capscrew and 3/4" locknut.
3. Attach the RH and LH pivot arm halves to the top holes on the mast. Place the mast spacer between
the mast and the pivot arms halves to the outside of the mast. Place a spacer bushing in each pivot
arm and install a 3/4" x 5-1/2" Capscrew and 3/4" Locknut.
4. Install the Driveline Holder to the right hand inside strut using the hole the shipping stand was bolted to.
Use the 1" x 2-1/2" capscrew, 1" lockwasher and 1" hex nut to attach the Driveline Holder.
SEMI MOUNT MODEL ASSEMBLY
1. Semi Mount Models do not require the Mast or Struts and Flex Links used on the 3 Point Lift models.
2. Cat.II Hitch Pins with Cat. III Bushings and Spacer Bushings are shipped installed to the lift points
of the cutter.
3. Install the Driveline Holder to the right hand inside strut using the hole the shipping stand was bolted to.
Use the 1" x 2-1/2" capscrew, 1" lockwasher and 1" hex nut to attach the Driveline Holder.
2310 SERIES 10/19
© 2019 Alamo Group Inc.
ASSEMBLY
Spacer
3/4" Locknut
Bushing
Cat. II Bushing
Spacer Bushing
3 Point Lift and
3 Point Lift and
Semi Mount
Semi Mount
Assembly Section 3-5
Mast Spacer
Cat. I Hitch Pin
3 Point Lift and
Semi Mount
Spacer
Bushing
3/4" x 5-1/2"
Capscrew
3/4" x 4"
Capscrew
5/8" SAE
Flatwasher
5/8" SAE
Locknut
LH Mast
Publicidad
