Publicidad
Motor Shaft
Eje del motor
Arbre d'entraînement
du moteur
Groove
Ranura
Rainure
Replacing Belt
Lift Agitator Up
Unidad del agitador
Soulever l'agitateur
Carpet-Bare Floor
Selector Shaft
Eje del selector
carpet-bare floor
Arbre d'entraînement
du sélecteur
tapis/plancher
End Cap
Tapa del extremo
Bouchon
Cleaning Agitator
➢ ➢ Replace belt whenever a burning
rubber smell caused by excessive
slippage occurs.
➢ ➢ Place carpet-bare floor selector in
CARPET position
➢ ➢ Remove lower plate.
➢ ➢ Remove agitator by carefully lifting
out.
➢ ➢ Remove worn or broken belt.
➢ ➢ Clean agitator.
➢ ➢ Loop new belt (Panasonic Type UB8
only) around motor shaft and agitator
pulley; see illustration for correct belt
routing.
➢ ➢ Reinstall agitator back into nozzle
housing grooves.
➢ ➢ After reinstalling the agitator, turn it
by hand to make sure that belt is not
twisted or pinched and that all
rotating parts turn freely.
➢ ➢ Reinstall lower plate.
➢ ➢ Clean agitator after every five uses
and every time the belt is replaced.
➢ ➢ Remove lower plate.
➢ ➢ Cut off any carpet pile and lint
entangled around agitator with a pair
of scissors.
➢ ➢ Remove agitator.
➢ ➢ Remove any string or debris located
on the end caps, washers or agitator
shaft.
➢ ➢ Reinstall agitator and lower plate.
- 36 -
Publicidad
