Publicidad
E-Clip
Sujetador de E
Bride en E
Agitator Shaft
Eje del agitador
Arbre d'entraînement
Agitator Pulley
Polea del agitador
Poulie de l'agitateur
Push Off
Replacing Brushes
Card
Tarjeta
Carte
Right End Cap
Tapa del extremo
derecho
Bouchon droit
Agitator Holder
Soporte del agitador
Support de l'agitateur
Empuje hacia fuera
Pousser
Brush
Cepillo
Brosse
➢ ➢ When the bristles on the agitator are
worn so that they do not touch a card
held across the lower plate, the
brushes should be replaced.
➢ ➢ Remove lower plate and agitator.
➢ ➢ Remove the E-clip from agitator shaft
and end cap.
➢ ➢ Do not bend agitator shaft or lose E-
clip or spacer.
➢ ➢ Pull agitator shaft out of agitator
body.
➢ ➢ Pull, or pry out, agitator holder and
agitator pulley.
➢ ➢ Push each brush out of agitator body
as shown.
➢ ➢ Install new brushes by reversing
procedure.
➢ ➢ Reinstall agitator holder and agitator
pulley completely.
➢ ➢ Reinstall the agitator shaft, end cap
and E-clip.
➢ ➢ See exploded view for correct
assembly of parts.
➢ ➢ Position belt over agitator pulley on
the agitator.
➢ ➢ Reinstall agitator and lower plate.
- 38 -
Publicidad
