Descargar Imprimir esta página

Fanimation Cancun Manual Del Propietário página 3

Publicidad

Idiomas disponibles

Idiomas disponibles

This Manual is Designed to Make it as Easy as Possible for You
to Assemble, Install, Operate, and Maintain Your Ceiling Fan
Tools Needed for Assembly
• One Phillips head screwdriver
• One stepladder
• One ¼˝ blade screwdriver
WARNING
Before assembling your ceiling fan, refer to section on
proper method of wiring your fan (page 4). If you feel you
do not have enough wiring knowledge or experience,
have your fan installed by a licensed electrician.
For your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all
steps have been completed and will be helpful in finding your place should you be interrupted.
WARNING
Do not install or use fan if any part is damaged or
missing. This product is designed to use only those
parts supplied with this product and/or any accessories
designated specifically for use with this product by
Fanimation. Substitution of parts or accessories not
designated for use with this product by Fanimation could
result in personal injury or property damage. Contact
your retail store for missing or damaged parts.
1. Check to see that you have received the following
parts:
NOTE: If you are uncertain of part description, refer to
exploded view illustration. (Figure 1, page 11)
Fan Motor Assembly
Ceiling Canopy
Blade Set
• One wire stripper
• Three wire connectors
(supplied)
Unpacking Instructions
Switch Cup/
Adapter Assembly
(FP8009OB)
Canopy Screw Cover
Materials
Wiring outlet box and box connectors must be of type
required by local code. The minimum wire would be a 3-
conductor (2-wire with ground) of the following size:
Installed Wire Length
Up to 50 ft.
50 - 100 ft.
NOTE: Place the parts from the loose parts bags in a small
container to keep them from being lost. If any parts are missing,
contact your local retailer.
Fan Motor Assembly
Switch Cup/Adapter
Assembly (FP8009OB)
Switch Cup/Adapter
Assembly with Light Fitter
(FP8011OB)
Hanger Bracket
Downrod/Hanger Ball
Assembly
Ceiling Canopy
Canopy Screw Cover
Motor Coupling Cover
Blade Holder Arms
Blade Set
Glass Bowl (FP8011OB only)
Light Bulb (FP8011OB only)
Switch Cup/Adapter
Assembly with Light Fitter
(FP80011OB)
Blade Holders Arms
Motor Coupling Cover
Glass Bowl
(FP8011OB)
3
Wire Size A.W.G.
14
12
Hardware bags:
– -20 x 14 screws with lock washers
(blade holder to fan motor hub)
-24 x 7.5 washer-head screws
(blade to blade holder)
– Fiber washers
– Phillips screwdriver, 4˝
– Four wire connectors
– Chain fob/coupler
– Balance Kit
– Pull Chain Kits Asm. Light Kit
(FP8011OB only)
Hanger Bracket
Downrod/Hanger
Ball Assembly
Hardware Bag
60-Watt
Candelabra Bulbs
(FP8011OB)

Publicidad

loading

Este manual también es adecuado para:

Fp8009obFp8011ob