Fanimation Cancun Manual Del Propietário página 9

Housing/Switch Cup Adapter Assembly
1. Disassemb e l h t e h o s u n i
by removing three screws. (Figure 19)
2. Remove one of the three screws in the support
bracket. Slightly loosen the remaining two screws.
Assemble the adapter assembly to the housing support
bracket using the two key slots in the adapter assembly.
Replace the third screw and securely tighten all three
screws. (Figure 20)
3a. Securely attach the 9-pin switch cup connector to
the wiring harness socket within the adapter assembly.
(Figure 21a)
3b. <<FP8011OB ONLY>> Connect the 2-pin
connector from the switch cup housing light fitter to the
2-pin connector from the motor assembly.
(Figure 21b)
4. Install the housing switch cup onto the assembled
adapter with the three screws removed in step 1.
The fan speed pull chain need to align the hole of
guide in the light fitter. (Figure 22)
g / s w t i h c u c p a d a t p r e s a sembly
FP8009OB
HOUSING/SWITCH
CUP ADAPTER
SCREWS (3)
ADAPTER
ASSEMBLY
ADAPTER
ASSEMBLY
FP8009OB
9
FP80011OB
HOUSING/SWITCH
CUP ADAPTER
WITH LIGHT FITTER
Figure 19
Figure 20
Figure 21a
Figure 21b
FP80011OB
Guide
Figure 22