Filling The Bar And Chain Oil Reservoir - Oregon PS250 Manual De Instrucciones Original

uNPACKiNG AND ASSEMBLY
• After properly seating the aluminum
drive shaft, push down on the fiberglass
pole so that is slides into the opening of
the motor housing
• Locate the provided Allen screws and
place them into the holes on the red
cap The red cap on the motor housing
acts as compression fit to hold the pole
in place
• use the supplied 4 mm Allen wrench
to partially tighten the Allen screws
Continue tightening the screws by
alternating between screws until both
of the screws are tight Note: you may
need to press the red cap tighter onto
the motor housing to allow the screws
to make contact with the internal
threads
14
OREGON® Cordless Tool System
POLE SAW MODEL PS250
FILLING ThE BAR AND ChAIN
OIL RESERVOIR
IMPORTANT: BAR AND ChAIN OIL
PREVENTS PREMATURE WEAR.
NEVER OPERATE ThE POLE SAW
IF OIL IS NOT VISIBLE. ChECK OIL
LEVEL FREQUENTLY AND FILL AS
NEEDED.
bar and chain oil is required to properly
lubricate the guide bar and saw chain
The pole saw is equipped with an
automatic oiler that deposits oil on the
bar and chain when running, keeping
them properly lubricated use OREGON®
bar and chain oil for best results It is
specially designed to provide low friction
and faster cuts NEvER use oil or other
lubricants not specifically designed for
use on the bar and chain This can lead to
a clogged oil system, which may cause
premature wear of the bar and chain
• Place the pole saw on its side on a firm,
flat surface, so that the oil cap is on top
(Fig 7)
FiG. 7
• Clean any debris from the cap area
• Remove the cap
• Carefully pour the bar and chain oil into
the reservoir
• Replace the cap and make sure oil is
visible in the reservoir
If oil is not visible in the reservoir,
additional bar and chain oil is necessary
AC 1113 - F/N 563397