Operating The Pole Saw; Battery Pack And Charger - Oregon PS250 Manual De Instrucciones Original

OREGON® Cordless Tool System
POLE SAW MODEL PS250

OPERATING ThE POLE SAW

BATTERY PACK AND ChARGER

WARNING: TO REDUCE ThE RISK
OF ShOCK, DO NOT ChARGE ThE
BATTERY PACK IN ThE RAIN.
BATTERY PACK LED ChARGE-LEVEL
INDICATOR
The lithium ion battery pack is equipped
with an LED charge-level indicator To test
the charge level of the battery pack, press
the indicator button on the battery pack's
face (Fig 15)
No lights: recharge
One steady green light:
less than 25% charged
Charge battery pack before use
Two steady green lights:
26–50% charged
Three steady green lights:
51–75% charged
Four steady green lights:
76–100% charged
FiG. 15
iNDiCATOr BuTTON
iNDiCATOr LiGHTS
CONNECTING ThE ChARGER
If the charger includes a separate power
cord, connect the charger cord to the
charger and to the proper electrical outlet
(Fig 16)
FiG. 16
AC 1113 - F/N 563397
OPErATiNG THE POLE SAW
Only use the cord set that was supplied
with the charger At first use, verify that
the plug type matches the receptacle
ChARGER LED ChARGE-STATE
INDICATOR
The battery charger is equipped with
an LED charge-state indicator that
indicates the state of charging as
well as conditions that may delay or
prevent charging (Fig 17)
Note: until a battery pack is inserted, no
lights will be visible
blinking orange light: a fault
condition exists There are
several potential causes See
"Troubleshooting" in this manual
Steady orange light: the battery
pack temperature is beyond the
acceptable range (32°F/0°C to
104°F/40°C) Allow the battery pack
to reach the acceptable
temperature range before
charging The pack may be left on
the charger as the temperature
adjusts Charging will begin when
the proper temperature is
reached
FiG. 17
blinking green light: battery pack
is charging
Steady green light: battery pack is
ready for use
17