Publicidad
2.
Adjust the Handle Assembly
Accessories
Accessoires
Accesorios
B
A
C
Accessories and Combined Accessories/Accessoires et accessoires
combinés/ Accesorios y accesorios combinados
Mixed Water Supply
Control Knob Detent
Alimentation d'eau
Détente du bouton de commande
mélangée
Retén de la perilla de control
Suministro de agua
mezclada
NOTE: Valve Operation. Water will flow from a single shower accessory when the
control knob detent lines up with any of the large detents on the escutcheon. Water
will flow from two accessories at the same time when the control knob detent lines
up with a small escutcheon detent.
Ensure the valve stem adapter is lightly placed over the spline adapter.
Place the handle assembly over the valve stem adapter.
Turn on the water supply to the transfer valve.
Rotate the handle assembly until water begins to flow through the shower
accessory.
Determine the shower accessory that will correspond to the Accessory "A" setting
at the 12 o'clock position on the escutcheon.
Turn the handle to the detent setting that corresponds with Accessory "A." The
handle should be in the vertical 12 o'clock position.
Repeat for each detent.
Remove the handle assembly and set aside.
To adjust for handle alignment:
NOTE: The spline adapter allows fine adjustment of the handle alignment.
Remove the handle assembly and the valve stem adapter.
Reposition the spline adapter.
Reinstall the handle assembly and the valve stem adapter.
Check the alignment. Repeat this procedure until the handle alignment is
satisfactory.
Kohler Co.
Transfer Valve/Valve de transfer/Válvula de transferencia
Spline Adapter/Adaptateur à cannelures/
Adaptador de ranuras
Valve Stem Adapter
Adaptateur de tige de valve
Adaptador de la espiga de la válvula
Handle Assembly/Ensemble de poignée/
Montaje de manija
A + C
C
B + C
5
A
A + B
B
1091245-2-A
Publicidad
