Kohler K-T10582 Guia De Instalacion página 4

Threaded Spouts
Nipple
Apply plumbers
putty.
4-1/2"
(11.4 cm)
1. Install the Spout
CAUTION: Risk of internal seal damage. Loosen the spout
setscrew with a 5/32" hex wrench prior to installing the spout.
CAUTION: Risk of internal seal damage. Do not use
petroleum-based lubricants. If the spout will not slide over the
tubing, use soapy water or silicone-based lubricant.
Threaded Spouts
Remove the temporary nipple from the bath elbow.
Apply thread sealant and install a 1/2" NPT nipple to extend
4-1/2" (11.4 cm) beyond the finished wall.
Apply a bead of plumbers putty or other sealant around the
spout base according to the manufacturer's instructions. Leave a
small gap free of putty or other sealant at the bottom of the
spout.
Apply thread sealant to the nipple threads and install the spout
to the nipple.
Carefully tighten with a clean strap wrench.
Remove all excess putty.
Slip-Fit Spouts:
Remove the temporary nipple from the bath elbow.
1036173-2-A
Slip-Fit Spouts
Apply
Copper Tube
plumbers putty.
2-1/8"
(5.4 cm)
to 3-1/2"
(8.9 cm)
Setscrew
5/32" Hex
Wrench
4 Kohler Co.