BABYTREND TS42B Manual De Instrucciones página 7

INFANT CAR SEAT
INFANT CAR SEAT ATTACHMENT
with CHILD TRAY INSERT
WARNING:
Failure to
follow these car seat attachment
instructions could result in
serious injury or death.
• Put the stroller seat in the full recline
12)
position (Fig. 11a). Turn car seat support
tabs on the stroller frame (Fig 12a).
Position the infant car seat so that it
faces toward the rear of the stroller.
Place the car seat so that it is cradled
on the inside of the front tray. Ensure the
car seat stoppers are resting on the tray
(Fig. 12b). When the infant car seat is
seated firmly into place, strap both short
clip over the infant car seat through the
seat belt slots on the infant car seat and
pull the strap adjuster tight (Fig. 12c).
Car Seat Support Tabs are Only used for
the infant car seat. Check that the front
child tray is firmly attached to the stroller
armrests.
NOTE: It is very important that the
short clip is always tightly fastened
around the infant car seat. Always
secure your child with the car seat
harness when using the car seat in
the stroller. If your child is already in
the car seat, check that the child is
secured with the harness. Improper
use of the stroller with the car seat
may result in serious injury or death.
• To remove the Infant Car Seat, remove
both of the short clips from the seat
belt slots on the infant car seat and pull
the Infant car seat upwards (Fig. 12d).
Rotate the support tabs up when not
using the car seat (Fig. 12a).
11
Copyright © 2018, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Fig. 12a
Fig. 12b
Pull
Pull
Fig. 12c
INFANT CAR SEAT
INFANT CAR SEAT ATTACHMENT with
CHILD TRAY ONLY
• Revert to page (5) and follow step (Fig 13d).
13)
Put the stroller seat in the full recline position
(Fig. 11a). Push down car seat support tabs
on the stroller frame (Fig 13a).
Car Seat Support Tabs are Only used for the
infant car seat. Check that the front child tray
is firmly attached to the stroller armrests.
• Position the infant car seat so that it faces
toward the rear of the stroller. Push the car
seat into the front tray until it latches into
place (Fig. 13b). The rear of the car seat
rests on the support tabs. Put the stroller
seat in the most upright position for additional
support (Fig. 11b). Strap the 2 short clips,
see step 12 for importance and content.
• To remove the Infant Car Seat, Remove the
short clips (Fig. 12c), squeeze the release
handle located at the Top-rear of the seat
and carefully lift upward on the seat
(Fig. 13c). Rotate the support tabs up when
not using the car seat (Fig. 13a).
Fig. 13b
Copyright © 2018, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Fig. 12d
Fig. 13a
Fig. 13c
12