Beurer BF 180 Manual De Instrucciones página 11

1.2 General notes
• Not intended for medical or commercial use.
• Please note that measuring tolerances are possible due to technical reasons because the scale has not been
calibrated.
• Ages 10 to 99 years and height settings from 100 to 220 cm (3-03" to 7-03") can be preset. Load capacity: max.
180 kg (396 lb, 28 st). Result in steps of 100g (0.2 lb, 1/4 st). Measurements of body fat, body water and muscle
density in steps of 0.1%.
• The caloric requirements is specified in steps of 1 kcal.
• When supplied to the customer, the scale is set to weigh and measure in "kg" and "cm".
On the back of the scale, there is a toggle button where you can select "pounds" (lb) and
"stones" (st).
• Place the scale on a firm level floor; a firm floor covering is required for correct measurement.
• Protect the scale against hard knocks, moisture, dust, chemicals, major temperature fluc-
tuations and heat sources which are too close (stove, heating radiator).
• Repairs may only be carried out by customer service or authorized dealers. Before submitting any complaint,
first check the batteries and replace them if necessary.
2. Operation
2.1 Batteries
If present, pull the battery insulating strip o the battery compartment cover or remove the bat-
tery's protective film and insert the battery according to the polarity. If the scale fails to operate,
remove the battery completely and insert it again. Your scale is equipped with a "replace battery"
indicator. When the scale is operated with a battery which is too weak, "Lo" appears in the display
field and the scale automatically switches o . In this case the batteries must be replaced (2x CR
2032).
2.2 Measuring weight only
Step onto the scale. Stand still with your weight distributed equally on both feet. The scale begins
to take measurements straight away. If the display appears continuously, the measurement has
finished.
If you step o the weighing area, the scale switches o after a few seconds.
2.3 Setting user data
To measure your body fat percentage and other physical data, you must enter your personal user para meters.
The scale has 10 memory positions in which you and other members of your family can save and recall personal
settings. Please note that the memory begins with 1.
Switch on the scale (tap the standing surface). Wait until the display shows "0.0".
Then press "SET". The first memory position will appear flashing on the display. Now you can enter the following
settings:
Memory position
Body size
Age
Sex
Degree of activity
– Modifying values: Press
– Confirming entries: Press the "SET" button.
– After the values have been set and displayed again, "0.0" appears on the display together with the symbol for
the selected gender /
– Then the scale is ready for measuring. If you do not carry out a measurement, the scale switches o automati-
cally after several seconds.
1 to 10
100 to 220 cm (3'-03" to 7'-03")
10 to 99 years
male ( ), female ( )
1 to 5
or or press and hold for more rapid progress.
.
11
UNIT