Publicidad
Idiomas disponibles
Idiomas disponibles
en-us
Faults – what to do?
Dispenser
Ice is being produced and dispensed but no water.
Fault with the appliance.
Dispenser not working.
Controls for dispenser panel lock are locked (child
lock).
Ice cubes may freeze together and block the dispenser
or the ice maker.
After switching on or removing many ice cubes, there
will be too few in the ice cube container.
Water tank is filling up.
Low water pressure.
The water filter/particle filter is blocked or needs to be
replaced.
The ice maker is not functioning.
Ice cube production is switched off.
Freezer compartment is too warm.
Ice cube container is not properly inserted.
Ice maker without power.
No water supply.
Low water pressure.
Kink in water hose.
32
Call customer service.
~ "Customer service" on page 34
Unlock controls for dispenser panel lock.
1.
Open the door. Check inside whether ice cubes are
stuck in the dispenser.
2.
If the dispenser is not blocked, carefully pull the ice
cube container out.
CAUTION
A full ice cube container is heavy!Use both hands
and proceed slowly.
3.
Remove the ice cubes which are frozen together.
It takes around 24 hours for an empty ice cube con-
tainer to fill up.
When used for the first time, the water tank takes
around 2 minutes to fill up.
Only connect appliance to pipes with sufficient water
pressure.
Replace water filter / clean particle filter.
Switch on ice cube production.
Set the temperature lower.
~ "Operating the appliance" on page 15
Insert ice cube container fully.
Call customer service.
~ "Customer service" on page 34
Check water connection and contact technician if nec-
essary.
Only connect appliance to pipes with sufficient water
pressure.
Turn off water supply, straighten out kink. Replace
water hose, if necessary.
Publicidad
