Publicidad
Idiomas disponibles
Idiomas disponibles
VHS 120 L, M, H
Optional Kits
Please contact the manufacturer's sales network for
information on optional kits.
Instructions for installing the optional are included in the
conversion kit.
Use only genuine optional kits supplied and
authorized by the manufacturer.
Optional kits must be installed by qualified Nilfisk
personnel.
Accessories
Various accessories are available; refer to the manufacturer's
accessory catalogue.
Use only genuine accessories supplied and
authorised by the manufacturer.
Packing and unpacking
Dispose of the packing materials in compliance with the laws
in force.
MODEL
VHS120 L
VHS120 M
VHS120 H
(*) Weight with packing
I
GB
E
E
C438
WARNING!
WARNING!
Figure 3
A
B
C
mm
mm
mm
700
790
1500
700
790
1500
700
790
1500
Unpacking, moving, use and storage
Operate on flat, horizontal surfaces.
The load-bearing capacity of the surface the vacuum cleaner
is placed on must be suitable for bearing its weight).
Setting to work - connection to the power
supply
■
Make sure there is no evident sign of damage to
the vacuum cleaner before starting work.
■
Before plugging the vacuum cleaner into the
electrical mains, make sure the voltage rating
indicated on the data plate corresponds to that of
the electrical mains.
■
Connect the plug into a socket with a correctly
installed ground contact/connection.
■
Make sure that the vacuum cleaner is turned off.
■
The plugs and connectors of the connection
cables must be protected against splashes of
water.
■
Make sure that connections to the electrical
mains and plug are correct.
■
Use the vacuum cleaners only when the cables
that connect to the electricity mains are in perfect
condition (damaged cables could lead to electric
shocks!).
■
Regularly check there are no signs of damage,
excessive wear, cracks or ageing on the electric
cable.
kg (*)
53
When the device is operating, do not:
66
■
Crush, pull, damage or tread on the cable that
connects to the electrical mains.
68
■
Only disconnect the cable from the electrical
mains by removing the plug (do not pull the
cable).
■
Only replace the electric power cable with one
of the same type as the original: H07 RN - F. The
same rule applies if an extension is used.
■ The cable must be replaced by the
manufacturer's Service Centre staff
or by equivalent qualified personnel.
6
WARNING!
WARNING!
07/2018
Publicidad
