Publicidad
Idiomas disponibles
Idiomas disponibles
VHS 120 L, M, H
Replacement of dust bags
Before proceeding with these
operations, turn off the vacuum cleaner
and remove the plug from the power
socket.
■
These operations can only be carried out by
trained and qualified personnel who must wear
adequate clothing, in compliance with the laws in
force.
■
Take care not to raise dust when this operation is
carried out. Wear a P3 protective mask.
■
In case of hazardous and/or harmful dust, use
only the bags recommended by the manufacturer
(see "Recommended spare parts").
■
The bag must only be disposed of by qualified
personnel and in compliance with the laws in
force.
Installing a paper bag not suitable for the class of dust
to be vacuumed, or incorrect installation, can create a
health risk for people exposed.
I
GB
E
E
C438
WARNING!
WARNING!
WARNING!
How to replace the Dust Bag
■
Close the inlet by using the relevant cap (1).
■
Release the dust container.
■
Remove the bag and close it with the relevant cap (2) as
shown in the figure.
■
Insert a new bag, making sure the bag inlet is sealed.
■
Place the dust container in the vacuum cleaner.
Use only original Nilfisk bags.
How to replace the Safe Bag
■
Remove and put the vacuum hose in a safe and dust-
free place.
■
Close the inlet by using the relevant cap (1).
■
Release the dust container.
■
Close the Safe Bag by pulling the "guillotine" seal (2).
■
Close the plastic bag hermetically using the relevant
band (3).
■
Use the sticky tape (4) to close the bottom of the plastic
bag.
■
Remove the relevant connection (5) of the bag from the
inlet.
■
Insert a new safe bag, making sure the vacuum inlet
is well connected to the bag attachment, to grant the
sealing.
■
Wrap the plastic bag around the dust container external
wall.
■
Place the dust container in the vacuum cleaner.
Only use bags suitable for the vacuum cleaner class
you are using.
Use only original Nilfisk bags.
How to replace Longopac
(VHS120 M-H)
■
Turn the bag full of dust (1, Fig. 10) on itself to obtain a
section of coiled bag to be tightened with two clamps (2,
Fig. 10).
■
Place the two clamps at a distance of 50 mm between
them, then with a pair of scissors cut between the two
clamps.
Remove the bag full of dust (1, Fig. 10) and place the
■
new section of Longopac
12
Figure 8
WARNING!
Figure 9
WARNING!
WARNING!
bags for hazardous dust
®
Figure 10
(3, Fig. 10).
®
07/2018
Publicidad
