Carrying Out A Measurement; Preparation; Operating The Instrument - Chauvin Arnoux C.A 6630 Manual De Instrucciones

Battery Tester C.A 6630

4 CARRYING OUT A MEASUREMENT

4.1

PREPARATION

To ensure your safety, the following safety procedures must be observed when
using your C.A 6630 :
•
before opening the instrument to replace the batteries, disconnect the
measurement leads from the battery being tested.
•
do not mix old and new batteries, nor batteries of different types and
specifications
•
note and observe the polarity of the batteries before inserting them in the
instrument
•
do not short-circuit or damage used batteries or expose them to a naked
flame. As this may cause them to explode.
4.2

OPERATING THE INSTRUMENT

•
connect the red measurement lead to the "+" terminal of the instrument
and the black measurement lead to the "-" terminal of the instrument
•
switch the C.A 6630 on by pressing key
•
connect the red contact tip to the positive terminal of the battery to be
tested and the black contact tip to the negative terminal of the battery to
be tested.
30
English