Publicidad
Idiomas disponibles
Idiomas disponibles
SM 1619X00459 12-04
STRAIGHT CUTTING
Once the rip fence is attached, measure from
the edge of work to the line of cut, and set edge
guide of rip fence to the same distance and
then
securely
(Fig. 12).
CIRCLE CUTTING
1. Before attaching the rip fence, draw a circle
and drive a finishing nail in the center of circle.
2. Drill or plunge cut near the circles edge,
turn saw off and disconnect the plug from
power source (Fig. 13).
FIG. 13
WEDGE
EDGE
GUIDE UP
3. Attach rip fence to saw with the edge guide
facing "up". In order for the rip fence to cut a
circle, the nail must be in alignment with the
blade, as shown in (Fig. 14).
12/3/04
3:50 AM
tighten
clamp
screw
FINISHING
NAIL
Page 11
FIG. 12
CLAMP
SCREW
LINE OF
CUT
FIG. 14
NAIL
4. Measure the distance from the selected
hole to the blade to be equal to the circle
radius.
5. Insert plug into power source, hold the saw
firmly, squeeze trigger and slowly push the
saw forward. To make a hole, cut from inside
the circle; To make wheels or discs, cut from
the outside.
Cutting Tip: Cut slowly so the blade will stay
straight in the cut. Place small wedges in the
cut as shown in Fig. 13, to keep the inner
circle from spreading when near the end of
the cut.
-11-
DESIRED
WIDTH
BLADE MUST BE IN
ALIGNMENT WITH NAIL
Publicidad
