Manuales relacionados para StarTech.com ARMPIVOTE2
Resumen de contenidos para StarTech.com ARMPIVOTE2
- Página 1 Desk Mount Articulating Arm with Cable Management and Spring Assisted Height Adjustment Actual product may vary from photos User Manual SKU: ARMPIVOTE2 For the latest information and specifications visit www.startech.com/ARMPIVOTE2 Manual Revision: 10/28/2021...
- Página 2 This manual may make reference to trademarks, registered trademarks, and other protected names and/or symbols of third-party companies not related in any way to StarTech.com. Where they occur these references are for illustrative purposes only and do not represent an endorsement of a product or service by StarTech.com, or an endorsement of the product(s) to which this manual...
- Página 3 Säkerhetsåtgärder • Installation och/eller montering får endast göras av behöriga yrkespersoner och enligt gällande lokala förordningar för säkerhet och byggnormer. To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support...
- Página 4 • Skärmfästets viktkapacitet: 17.6 lb (8 kg). • Låt inte barn klättra på produkten eller använda produkten utan uppsikt. • Produkten är endast avsedd för användning inomhus och ska inte användas utomhus. To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support...
- Página 5 • Voordat u apparatuur aan dit product toevoegt, moet u ervoor zorgen dat u het op de juiste manier in elkaar hebt gezet en geïnstalleerd, en dat het product het gewicht van de toe te voegen apparatuur kan ondersteunen. To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support...
- Página 6 • 本製品は、 二人がかりでの組み立てを想定しています。 手助けなしに単独で 組み立てと設置を行わないで下さい。 • コードやケーブルの上、 または凹凸のある床面でカートを移動させないで 下さい。 • 反動注意! 本製品にはスプリング機構が搭載されており、 作動させるとアセ ンブリ部品やディスプレイが反動で上方向に大きく動く場合があります。 付 属の説明書に従い、 ハンドルを操作する際には常に注意を払ってください。 設置手順のステップ4より前にハンドルを操作しないでください。 ディスプ レイの高さを調整するときは、 必ず両手でディスプレイを支え、 ハンドルを 握って安全にディスプレイの昇降をコントロールしてください （図参照） 。 誤 った操作をすると、 破損や怪我につながる可能性があります。 • 危険 ！ 可動部品に近づかないでください。 To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support...
- Página 7 à assembler et utiliser ce produit. • Ne dépassez pas la capacité pondérale du produit. Une surcharge du produit peut entraîner des blessures ou des dommages matériels. To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support...
- Página 8 • Montar este produto é uma tarefa para duas pessoas. Não tentar montar este produto e instalar o equipamento sem assistência. To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support...
- Página 9 • Antes de empezar a mover el carrito, asegúrese de haber desbloqueado las ruedas. Antes de empezar a mover el carrito, asegúrese de haber desbloqueado las ruedas. • ¡Peligro de Energía Almacenada! Este producto contiene un mecanismo de To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support viii...
- Página 10 Montagekomponenten und/oder das Display bei Betätigung gewaltsam und schnell nach oben bewegen. Befolgen Sie die mitgelieferten Anweisungen und lassen Sie bei der Betätigung des Griffs stets Vorsicht walten. Betätigen To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support...
- Página 11 Anheben oder Absenken des Displays sicher zu steuern. Andernfalls kann es zu Sachschäden und/oder schweren Personenschäden kommen. • Einklemmgefahr! Halten Sie Ihre Finger fern von beweglichen Teilen. To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support...
- Página 12 Attach the VESA Mount ........................... 13 Operation ....................16 Adjusting the Tilt Resistance ......................... 16 Adjusting the Swivel Resistance ......................16 Cable Management ..........................17 Warranty Information ................18 Limitation of Liability ................18 To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support...
- Página 13 Product Diagram Pole Assembly Desk Clamp Arm Assembly Pressure Plate VESA Mount Bottom Plate Cable Management Hand Screw Attachment To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support...
- Página 14 For the latest product information, technical specifications, manuals, and Declarations of Conformance, please visit: www.StarTech.com/ARMPIVOTE2 Tools Phillips Head Screwdriver x 1 • To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support...
- Página 15 Package Contents VESA Mount Pole Assembly Arm Assembly M4 x 12 mm Screws Qty: 1 Qty: 1 Qty: 1 Qty: 4 Cable 3 mm Hex Key M4 x 30 mm Spacers Management Screws Qty: 1 Qty: 4 Clip Qty: 4 Qty: 1 Cable M5 x 6 mm...
- Página 16 Grommet Plate User Manual Qty: 1 Qty: 1...
- Página 17 Screw Pressure Plate Washer Bottom Plate Hand Screw Figure 2 Detach the Pressure Plate and Washer from the Hand Screw. Detach the Hand Screw from the Bottom Plate. To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support...
- Página 18 4 mm Hex Key. (Figure 4) Figure 4 Affix the Rubber Pad to the Grommet Plate to complete the Grommet Mount Pole Assembly. Position the Grommet Mount Pole Assembly over a Grommet Hole. To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support...
- Página 19 Insert the Hand Screw through the Pressure Plate and up into the Grommet Mount Pole Assembly. (Figure 5) Grommet Mount Pole Assembly Mounting Surface Pressure Plate Hand Screw Figure 5 Tighten the Hand Screw until hand-tight. To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support...
- Página 20 Surface. (Figure 6) Desk Clamp Mounting Surface Figure 6 3. Tighten the Hand Screw, located on the Pole Assembly, by hand or by using the 5mm Hex Key, until hand-tight. To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support...
- Página 21 Remove the Screw from the Pressure Plate, using a Phillips Head Screwdriver. (Figure 8) Screw Pressure Plate Washer Bottom Plate Hand Screw Figure 8 Detach the Pressure Plate and Washer from the Hand Screw. To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support...
- Página 22 5 mm Hex Key. 9. Loosen the Hand Screw, located on the Desk Clamp, until the Desk Clamp is wider than the thickness of the Mounting Surface (e.g. Desk or Table). To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support...
- Página 23 (Figure 10) Desk Clamp Mounting Surface Figure 10 11. Tighten the Hand Screw, located on the Desk Clamp, by hand or by using the 5mm Hex Key, until hand-tight. To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support...
- Página 24 Management Attachment Figure 12 Thread three M5 x 6 mm Screws through the Cable Management Attachment and into the Arm Assembly and tighten, using a Phillips Head Screwdriver. To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support...
- Página 25 Note When attached, the Arrow on the VESA Mount should be pointing toward the top of the Monitor. VESA Mount Figure 13 Aligning the VESA Mount with Monitor To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support...
- Página 26 Screws, stop tightening. Failure to do so could result in damage to the Monitor. Note: It is recommended that two people mount the Monitor. To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support...
- Página 27 VESA Mount, with the VESA Holder, located on the Arm Assembly. Slide the Mounting Plate down into the VESA Holder. While holding the Monitor in place, release the VESA Clip. To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support...
- Página 28 Adjust the swivel resistance, using the 5 mm Hex Key. Turn the 5 mm Swivel Screw counterclockwise to decrease the resistance and clockwise to increase it. (Figure 16) Figure 16 To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support...
- Página 29 Attachment, through the lower portion of the Arm Assembly, through the Cable Management Clip, and to the Power/Video Sources. (Figure 18) Arm Assembly Cable Management Attachment Monitor Cables Figure 18 To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support...
- Página 30 Limitation of Liability In no event shall the liability of StarTech.com Ltd. and StarTech.com USA LLP (or their officers, directors, employees or agents) for any damages (whether direct or indirect, special, punitive, incidental, consequential, or otherwise), loss of profits, loss of business, or any pecuniary loss, arising out of or related to the use of the product exceed the actual price paid for the product.
- Página 31 Hard-to-find made easy. At StarTech.com, that isn’t a slogan. It’s a promise. StarTech.com is your one-stop source for every connectivity part you need. From the latest technology to legacy products — and all the parts that bridge the old and new — we can help you find the parts that connect your solutions.