Publicidad
Detach the Hand Screw from the Bottom Plate, flip the
4.
Bottom Plate upside down, and reinsert the Hand Screw
into the Bottom Plate. (Figure 9)
Place the Washer and Pressure Plate atop the Hand Screw.
5.
Insert the Screw, removed in step 2, through the Pressure
6.
Plate and Washer and into the Hand Screw and tighten,
using a Phillips Head Screwdriver.
Align the holes in the Bottom Plate with the holes in the
7.
Pole Assembly.
Insert the Screws (x2), removed in step 1, through the
8.
Bottom Plate and into the Pole Assembly and tighten,
using the 5 mm Hex Key.
9. Loosen the Hand Screw, located on the Desk Clamp,
until the Desk Clamp is wider than the thickness of the
Mounting Surface (e.g. Desk or Table).
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
Figure 9
10
Publicidad
