Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLING THE ARM
1. Align the holes in the arm (F) with the
holes on the left of the frame (E)
(see FIGURE 5).
2. Put 3 pins (I) into the holes on the arm.
3. Insert 3 screws and nuts (I) and slightly
tighten nuts from the back of the frame.
4. Place 2 pins (I) into the holes on the left of
the arm.
5. Insert 2 screws and nuts (I) and slightly
tighten nuts from the back of the frame.
6. Tighten the 2 nuts on the arm, then tighten
the 3 nuts below on frame.
FIGURE 5
INSTALLING THE TRAY
1. Place the tray onto the stand. (see FIGURE 6)
FIGURE 6
INSTALLING THE WATER PUMP
(see FIGURE 7)
1. Place the pump in its designated location
inside the water tray.
2. Make sure drain plug is secured.
3. Plug the pump power cord into the 3-prong
receptacle on the side of the cutting head
assembly.
4. Make sure that the water valve
connecting the pump to the tubing is in the
full open position.
Water Pump
Water Pump
Drain Hole
FIGURE 7
ASSEMBLING THE SAW
1. Place the motor fixed to the frame into the
top of the tray. (see FIGURE 8)
FIGURE 8
ASSEMBLING THE TABLE
(see FIGURE 9)
1. Unlock the pin lock on the side of table (J)
– pull and turn 90°.
2. Align the wheels under the table to the
tray guide rails.
3. Slide the table (J) into the tray guide rails.
4. Secure pin lock in place on table (J) side –
push and turn 90°.
Table Lock
FIGURE 9
ASSEMBLING THE BLADE
1. Remove the inner flange and outer flange
from the arm (F). (see FIGURE 10A)
2. Place the inner flange, blade (K), and outer
flange onto the shaft. (see FIGURE 10B)
3. Secure with nut and tighten.
– 4 –
FIGURE 10A
FIGURE 10B
LASER GUIDE
SAFETY, NEVER CONNECT THE PLUG TO A
POWER SOURCE OUTLET UNTIL ALL THE
ADJUSTMENT STEPS ARE COMPLETE
AND YOU HAVE READ AND UNDERSTOOD
THE SAFETY AND OPERATIONAL
INSTRUCTIONS.
• LASER RADIATED WHEN LASER GUIDE
IS TURNED ON. AVOID DIRECT EYE
CONTACT.
• ALWAYS UNPLUG THE TILE SAW FROM
POWER SOURCE BEFORE MAKING ANY
ADJUSTMENTS.
• THE USE OF CONTROLS, ADJUSTMENTS,
OR PERFORMANCE OF PROCEDURES
OTHER THAN THOSE SPECIFIED HEREIN
MAY RESULT IN HAZARDOUS RADIATION
EXPOSURE.
• THE USE OF OPTICAL INSTRUMENTS
WITH THIS PRODUCT WILL INCREASE
Wheels
EYE HAZARD.
• DO NOT ATTEMPT TO REPAIR
OR DISASSEMBLE THE LASER. IF
UNQUALIFIED PERSONS ATTEMPT
TO REPAIR THIS LASER PRODUCT,
SERIOUS INJURY MAY RESULT. ANY
REPAIR REQUIRED ON THIS LASER
PRODUCT SHOULD BE PERFORMED
BY AUTHORIZED SERVICE CENTER
PERSONNEL.
NOTE: Your tool is equipped with a laser
guide using a laser beam. The laser beam
will enable you to preview the saw blade
path on the tile to be cut before starting the
saw. (see FIGURE 11)
• If you choose to use the laser guide, the
laser beam must be correctly aligned with
the blade to ensure straight, even cutting.
Blade
Rotation
Tighten
FOR YOUR OWN
Publicidad
