Publicidad
Idiomas disponibles
Idiomas disponibles
DIAMOND BLADE DO'S &
DON'TS
1. DO inspect blades daily for cracks or
uneven wear. Discard cracked, chipped or
bent blades!
2. DO use manufacturer's recommendation
for matching the right blade with the right
material being cut.
3. DO inspect the arbor shaft for uneven
wear before mounting the blade.
4. DO use blades with the correct arbor size
on a compatible arbor shaft.
5. DO ensure the blade is mounted with the
rotation arrow in the proper direction and is
securely tightened with a wrench.
6. DO wear proper safety equipment at
all times when operating the saw. Wear
goggles and dust mask at all times when
operating saw.
7. DO periodically check the blade for cracks
or bond fatigue.
8. DO ensure that blade is traveling through
water reservoir for wet cutting.
1. DO NOT operate the saw without all safety
guards in position.
2. DO NOT operate the saw with blades
larger or smaller than recommended.
3. DO NOT cut dry with blades marked
"Use Wet."
4. DO NOT exceed maximum RPMs
recommended by the blade manufacturer.
5. DO NOT force the material into the blade.
Let the blade cut at its own speed.
6. DO NOT cut material not recommended by
the blade manufacturer.
REPLACING THE BLADE
1. Remove the outer flange with wrench.
2. Ensure that the shaft and flanges are
clean.
3. Mount blade on to shaft with the
directional arrow on the blade rotating in the
same direction as the motor
(see FIGURE 22A)
4. Replace flange, lock nut, and tighten.
(see FIGURE 22B)
Blade
Rotation
FIGURE 22A
FIGURE 22B
TROUBLESHOOTING
OVERHEATING OF SAW:
1. Turn saw off and let it rest until motor is
cool to the touch.
2. Check and clean the ventilation slots,
removing blockage and dirt.
THE SAW DOES NOT START:
1. Check that power cord is properly
plugged in.
2. Check outlet power source and circuit
breaker.
WATER IS NOT FLOWING:
1. Make sure water level in tray is high
enough to clear the intake nozzle.
2. Make certain the water valve connecting
the pump to the tubing is in the "ON"
position.
3. Check water hose for connection or clogs.
4. Check that the power cord is plugged in
properly.
5. Check for excess debris on intake filter.
THE CUTTING TABLE IS NOT
SLIDING SMOOTHLY:
1. Thoroughly clean guide rails.
CUSTOMER SERVICE:
1-866-435-8665
Tighten
– 7 –
Publicidad
