Publicidad
Idiomas disponibles
Idiomas disponibles
enGlisH
seCtion tHree
programming
The HRC-050 has two programs you may setup to control a variety of watering
plans . Depending on your needs, you may use either or both programs .
enter the Watering schedule in any order
You have the option of entering your watering schedule in whatever order
you like . This feature makes it very easy to review and change your watering
schedule . Your settings can be changed at any time–while you're setting up the
initial schedule, or after years of operation .
start times for program a or B
A start time is the time of day that the program begins watering the first
station, and all other stations will then follow in sequence . There are not
separate start times for each station . Start times do not correspond to specific
stations . If you enter more than one start time, all stations programmed to
operate will water again (in sequence) .
• The way you set the start time is the same for both programs. Turn the rotary
dial to the Start Times position in the program that you want to set . The
display will show an A or B depending on which program you have selected .
The display will show – – : – –, and a blinking cursor in Start 1 location
[See Figure 4] .
9
Figure 4: LCD Display with Start Time
• Set the time you want to begin watering for start time 1 using the + or – keys,
then press the enter key . The display will advance to Start 2 . For additional
start times, simply repeat this procedure by using the + and – keys to enter
the time, then press enter . Remember, each start time will activate all
stations that are programmed to operate . There are not separate start times
for each station . Start times do not correspond to specific stations .
• Up to four start times can be entered per program (A or B
Watering durations for program a or B
The way you set the watering duration is the same for all programs . To set the
duration for each program you will be using, do the following:
(Note: Both programs require watering durations to be programmed.)
• Turn the rotary dial to the Station Duration position in either the A or B
program . The display will show which program you have selected with an "A"
or "B" and the
– – MINS and the cursor blinking at station "1" [See Figure 5] .
10
Publicidad
