Publicidad
Idiomas disponibles
Idiomas disponibles
Grounding installation
GB
This appliance is classified as protection class I and must be
connected to a protective ground. Grounding reduces the risk
of electric shock by providing an escape wire for the electric
current.
This appliance is fitted with a power cord with grounding plug
or electrical connections with grounding wire. The connec-
tions must be properly installed and grounded.
Preparation before use
• Remove all protective packaging and wrapping.
• Check that the device is in good condition and with all acces-
sories. In case of incomplete or damaged delivery, please
contact the supplier immediately. In this case, do not use
the device.
• Clean the accessories and the appliance before use (See ==>
Cleaning & Maintenance).
• Make sure the appliance is completely dry.
• Place the appliance on a horizontal, stable and heat resist-
ant surface that is safe against water splashes.
• Keep the packaging if you intend to store your appliance in
the future.
• Keep the user manual for future reference.
NOTE! Due to manufacturing residues, the appliance may
emit a light odor during the first few uses. This is normal and
does not indicate any defect or hazard. Make sure the appli-
ance is well ventilated.
Installation / Assembly & Disassembly
• Place the auger on the base unit: place the auger on the
triangular shaped axle of the base unit.
• Place the pipe holder on the bottom of fountain pipe.
• Place the fountain pipe over the auger and line up the three
holes of the pipe holder with the pins on the base unit while
placing the fountain pipe on the base unit.
• The chocolate fountain is now ready for use.
Operating instructions
• Switch position: Left is for the motor, Right is for the heater.
• Turn on the heating element to preheat the chocolate foun-
tain around 3 - 5mins.
• Prepare 1500 grams of chocolate as follows:
- Put the chocolate in a heat-resistant bowl.
- Put the bowl in a pot with warm water (60°C). NOTE! Don't
let the water boil.
- Stir the chocolate until is has melted completely. Do not
add water to or spil water into the chocolate.
- The chocolate has to be fluid (like yoghurt). If that is not
the case, add some tasteless vegetable oil (sun flower) to
it.
• Turn on the motor and pour the chocolate into the lower
bowl.
• The auger moves the chocolate up.
• You can start now.
• Only use fruit that is sufficiently cooled and has a dry sur-
face. The low temperature of the fruit helps the chocolate
to solidify and the dry surface helps the chocolate to attach
easier to the fruit. Too much moist/water will deteriorate
the consistancy of the chocolate.
NOTE! Air bubbles in the fountain pipe disrupt the evenly flow
6
of chocolate. In which case you must turn off the motor and
wait for the air bubbles to escape from the fountain pipe (this
may take a few minutes). It is normal for air to escape at the
bottom of the fountain pipe during this procedure. Switch the
motor on again if the fountain pipe is free of air bubbles.
Cleaning & maintenance
• ATTENTION! Always disconnect the appliance from the
power supply and cool down before storage, cleaning &
maintenance.
• Do not use water jet or steam cleaner for cleaning and do
not push the appliance under the water as the parts will get
wet and electric shock might be resulted.
• If the appliance is not kept in a good state of cleanliness, this
can adversely affect the life of the appliance and result in a
dangerous situation.
• Food residues should be regularly cleaned and removed
from the appliance. If the appliance is not cleaned proper-
ly, it will reduce its lifespan and may result in a dangerous
condition during use.
Cleaning
• Clean the cooled exterior surface with a cloth or sponge
slightly dampened with a mild soap solution.
• For reasons of hygiene, the appliance should be cleaned
before and after use.
• Avoid water contacting the electrical components.
• Clean the inside of container with a non-abrasive detergent
and rinse with clean water.
• Never immerse the appliance in water or other liquids.
• Never use aggressive cleaning agents, abrasive sponges, or
cleaning agents containing chlorine. Do not use steel wool,
metallic utensils, or any sharp or pointed objects for clean-
ing. Do not use petrol or solvents!
• No parts are dishwasher safe.
Maintenance
• Check the operation of the appliance regularly to prevent
serious accidents.
• If you see that the appliance is not working properly or that
there is a problem, stop using it, switch it off and contact
the supplier.
• All maintenance, installation and repair work must be car-
ried out by specialised and authorised technicians, or rec-
ommended by the manufacturer.
Transportation and Storage
• Before storage, always make sure that the appliance has
been disconnected from the power supply and completely
cooled down.
• Store the appliance in a cool, clean and dry place.
• Never place heavy objects on the appliance as this could
damage it.
• Do not move the appliance while it is under operation. Dis-
connect the appliance from power supply when moving and
hold it at the bottom.
Troubleshooting
If the appliance does not function properly, please check the
below table for the solution. If you are still unable to solve the
problem, please contact the supplier/service provider.
Publicidad
