Titan 0524369H Instrucciones De Uso página 5

Operation
Use the following procedures to operate the spray system.
Priming the Pump
Preparing to Prime
1. Fill the inlet valve with water or with a light household oil.
2. Make sure that the PRIME/SPRAY valve is set to PRIME and that
the pressure control knob is turned counterclockwise to its
lowest pressure setting.
3. Turn on the pump by moving the pump ON/OFF switch to the
ON position.
4. Increase the pressure by turning the pressure control knob
clockwise 1/2 turn.
5. Force the inlet valve to open and close by pushing on it with
a screwdriver or the eraser end of a pencil. It should move up
and down about 1/16 of an inch. Continue until water or oil
is sucked into the pump. This will wet the moving parts and
break loose any old paint residue.
6. Put the palm of your hand over the inlet. Turn the pressure
control knob clockwise to its maximum setting. You should
feel suction coming from the inlet valve. If you do not, refer
to the "Removing and Cleaning the Outlet Valve" procedure in
the Maintenance section.
7. Turn the pressure control knob counterclockwise to the
minimum pressure setting.
8. Turn the pump ON/OFF switch to OFF.
© Titan Tool. All rights reserved.
PRIME/SPRAY
Valve
Mounting the Hopper Assembly
Use the following procedure to mount the paint hopper and attach
the return tube on a hopper unit.
1. Screw the return tube fitting into
the return tube port on the side of
the pump.
NOTE: Do not over-tighten. Hand-
tighten only. Some threads
will be visible even when
fully tightened.
2. Align the bottom of the paint
hopper with the threaded inlet
valve on the paint pump block.
3. Turn the paint hopper clockwise to thread it onto the inlet
valve. Continue to turn the paint hopper until it is secure on
the inlet valve.
NOTE: Make sure the threads are straight and the hopper
turns freely on the inlet valve. Do not cross-thread.
4. Place the filter screen into the bottom of the paint hopper and
snap it in position.
5. Make sure that the motor ON/OFF
switch is turned to OFF.
6. Place the straight end of the return
tube into the return tube fitting.
7. Thread the nut on the return tube
onto the return tube fitting and
tighten until the return tube is
secure.
8. Place the hook end of the return
tube into the hole in the paint
hopper cover.
Attaching the Optional Suction Set
Use the following procedure to attach the suction set to a suction set
unit.
1. Remove the hopper return tube
fitting. Screw the return tube fitting
into the return tube port on the
side of the pump.
NOTE: Do not over-tighten. Hand-
tighten only. Some threads
will be visible even when
fully tightened.
2. Align the nut on the suction set
with the threaded inlet valve on the
pump block.
3. Thread the suction hose nut onto the inlet valve on the pump.
NOTE: Make sure the threads are straight and the nut turns
freely on the inlet valve. Do not cross-thread.
4. Thread the return tube onto the return tube fitting on the
pump.
5
Inlet
Valve
Return Tube Fitting
Nut Return
Tube
Inlet
Valve
Return Tube Fitting
English