Publicidad
Idiomas disponibles
Idiomas disponibles
SPM ............. strokes per minute
sfpm ............. surface feet
.....................
per minute
.....................
SAVE THESE INSTRUCTIONS
Motor
Be sure your power supply agrees with the nameplate marking. Voltage
decrease of more than 10% will cause loss of power and overheating.
D
WALT tools are factory tested; if this tool does not operate, check
e
power supply.
FIG. 1
F
D
DWP849X
H
G
A
COMPONENTS (Fig. 1)
.....................earthing
terminal
or personal injury could result.
.....................safety alert
symbol
INTENDED USE
The DWP849X heavy-duty polisher is designed for polishing painted
or unfinished metal, fiberglass, and composite surfaces in professional
applications. Common examples of use include but are not limited
to: auto/marine/RV/motorcycle detailing and finish correction, boat
construction and repair, and metal or concrete finishing.
DO NOT use in the presence of flammable liquids or gases. DO NOT
let children come into contact with the tool. Supervision is required
A
when inexperienced operators use this tool.
E
Variable Speed Trigger Switch (Fig. 1)
This tool is equipped with a variable speed trigger switch that permits
speed control from 0 to 3500 RPM. To turn the tool on, squeeze the
trigger switch (B) shown in Figure 1 until the tool starts to run. The
farther you depress the trigger, the faster it will operate. Releasing the
trigger turns the tool off.
Use lower speeds for applying liquid waxes and polishes and higher
C
B
I
speeds for removing dried liquid. Use the highest speed (fully depress
trigger) for buffing the car to a final lustre.
The tool can be locked on for continuous use by squeezing the trigger
switch fully and depressing the lock button (E) shown in Figure 1. Hold
the lock button in as you gently release the trigger switch. The tool will
continue to run. To turn the tool off from a locked on position, squeeze
D
and release the trigger switch once. Do not unplug the tool with the
33
WARNING: Never modify the power tool or any part of it. Damage
A. Speed control wheel
B. Variable speed trigger switch
C. Brush inspection cap
D. Spindle lock button
E. Trigger locking button
F. Bale handle
G. Spindle
H. Soft rubber gear case cover
I. Wool ingestion shield
Publicidad
