Fulgor Milano F6RT30 Serie Manual De Uso & Mantenimiento página 10

&21752/ ,16758&7,216 )25 86(
This touch control works using optical light sensing
WHFKQRORJ\ :KHQ ¿UVW FRQQHFWLQJ HOHFWULFDOO\ RU
after a power failure, any direct strong light over the
sensor area may affect the touch control functionality.
When powering on the unit make sure that no strong
light is shining direct over the touch control zone,
it can compromise the start-up sensor calibration
resulting in an unresponsive touch control.
When the cooktop is connected to the electrical voltage
supply all lights and digits turn on to indicate a proper
activation. This operation will be completed after few
seconds, the control turns off automatically. Now the
cooktop is ready for operations.
6ZLWFKLQJ WKH FRQWURO RQ
(YHQWXDOO\ KROG WKH >/2&.@ NH\ LQ FDVH WKH FRPPDQGV
are locked (see that the lock led is on and turns off after
a few seconds).
7RXFK WKH PDLQ >212))@ NH\ LQ RUGHU WR PDNH HDFK
single zone available for selection.
All the displays show power level "0", if no actions are
performed the control shuts down again after about 10
seconds.
(OHPHQWV VHWWLQJ
7RXFK WKH SURSHU >21@ NH\ UHI LQ RUGHU WR VHOHFW WKH
desired zone: the HOT SURFACE (ref.3) indication
VWDUWV ÀDVKLQJ ZDLWLQJ IRU D XVHU LQSXW
5b
2
)LJXUH 
Touch the slide bar to set the power level (levels 0 to
DUH DYDLODEOH  PRYLQJ WKH ¿QJHU DORQJ LW RU GLUHFWO\
touching the desired value. If your cooktop model has
no slide bar.
10
WARNING
5a
4
1
3
The display (ref.4) and the "Peacock Tail" (ref.6) show
the power level, updated in real time.
After a 5 seconds time-out the value is accepted, the
+27 685)$&( OHG UHI VWRSV ÀDVKLQJ DQG JHWV
steady. The "Peacock Tail" disappears after some
seconds more.
7RXFK >21@ NH\ WR FRQ¿UP WKH YDOXH EHIRUH WKH WLPHRXW
expires.
The following picture represents the Full Power Scale
whereas the control uses all the available power range,
from 0% up to the 100% corresponding to level 9.
Level 4 corresponds to 15% of the available power.
6
7
Figure. 7
8VLQJ WKH /RZ 3RZHU 6FDOH
Once a cooking zone has been selected, touch the
>/2: 7(03@ NH\ UHI LQ RUGHU WR HQDEOH WKH /RZ
Power Scale (ref.9) then set the power level in the
usual way.
8
Figure. 8
Use & Care Manual
ENGLISH
9