Replacing The Paper Roll; Removing The Paper Roll - Sharp XE-A302 Manual De Instrucciones

4

Replacing the Paper Roll

Be sure to use paper rolls specified by SHARP.
The use of any other paper rolls other than those specified could cause paper jamming, resulting in register
malfunction.
Paper specification
Paper width: 2.25 ± 0.02 in (57.5 ± 0.5 mm)
Max. outside diameter: 3.15 in (80 mm)
Quality: Thermal paper
• Be sure to set the paper roll prior to using your machine, otherwise it may cause a malfunction.
Install the paper roll in the printer. Be careful to set the roll correctly.
(How to set the paper roll)

Removing the paper roll

When a red dye appears on the paper roll, it is time to replace it. Replace the paper roll with a new one. If you
plan on not using the register for an extended period of time, remove the paper roll, and store it in an appropriate
place.
Caution: The paper cutter is mounted on the printer cover. Be careful not to cut yourself.
When not using the take-up spool (using as receipt paper):
Print roller
release lever
When using the take-up spool (using as journal paper):
To the printer
Correct
1.
Remove the printer cover.
Print roller arm
2.
Lift up the print roller release lever to unlock and open the print
roller arm.
3.
Remove the paper roll from the paper roll cradle.
1.
Turn the mode switch to a position other than OFF with the
Area to cut
power cord connected.
2.
Remove the printer cover.
3.
Press the
part is out of the way.
4.
Cut the paper and remove the take-up spool.
5.
Lift up the print roller release lever to unlock and open the print
roller arm.
6.
Remove the paper roll from the paper roll cradle.
To the printer
Incorrect
Do not pull the paper through the printer.
F
key to advance the journal paper until its printed
Do not pull the paper through the printer.
69