Publicidad
Idiomas disponibles
Idiomas disponibles
Cutting in several passes
A = Mark cutting line
:
Work along the cutting line. If
corrections are necessary, always
reposition the cutting wheel, taking
care to ensure that it is not wedged.
The cutting depth per pass should
not exceed 5 to 6 cm (2" to 2 1/2".
Thicker material must be cut in
several passes.
TS 400
:
Thick-walled workpieces should be
cut with a uniform swinging
movement, back and forth.
English / USA
Cutting slabs
:
Place the slab securely on a non-
slip surface.
A = Cut a guiding groove along the
marked line.
B = Cut deeper into the parting cut with
uniform back-and-forth movements.
C = Leave a ridge of uncut material.
:
Cut through the slab at the ends so
the material does not chip.
:
Then break the slab.
19
Publicidad
