Toro 51487 Manual Del Operador página 5

Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
1
Mounting the Wall-Mounting
Bracket
Parts needed for this procedure:
2 Screw
1 Wall-mounting bracket
Procedure
Note: The bracket should be mounted indoors and out of the
reach of children.
1. Place the bracket against the wall and mark the 2 hole
locations.
2. Drill the pilot holes.
A. If mounting the bracket on wall board, plaster, or
cement, drill 2 holes for the wall anchors (not supplied)
at the marked locations.
B. If mounting the bracket on wood, drill 2 holes slightly
smaller than the diameter of the screw threads at the
marked locations.
3. Install the screws (Figure 1).
A. If mounting the bracket on wall board, plaster, or
cement, insert the 2 wall anchors (not supplied) into the
holes then thread the screws into the wall anchors.
B. If installing the bracket on wood, drive the 2 screws into
the wall.
Description
Screw
Wall-mounting bracket
No parts required
Auxiliary handle
Latch
Brace
Guard
Phillips head screw
Wire edge guard
No parts required
Qty.
2
Mount the wall-mounting bracket.
1
–
1
1 Install the auxiliary handle.
1
1
Mount the guard to the base of the
trimmer.
1
1 Install the edge guard
Adjust the trimmer height and base
–
orientation
G018599
5
Use
1
Figure 1