Descargar Imprimir esta página

Genebre IG20001-01 Instrucciones De Montaje página 4

Publicidad

Funcionamiento del Sensor /
Sensor Operation
El grifo electrónico Genebre se activa
cuando un objeto entra en el campo
del sensor, aproximadamente entre 10
y 15 cm. Cuando se supera 1 minuto el
tiempo de uso, se bloquea la salida de
agua hasta que el objeto sale del campo
a fin de evitar posibles inundaciones o
derrames, momento en el que vuelve
a trabajar normalmente.
The Genebre electronic tap is activa-
ted when an object enters the sensor
field, approximately between 10 to 15
cm. When the usage time is exceeded 1
minute, the water outlet is blocked until
the object leaves the field in order to
avoid possible floods or spills, at which
time it returns to work normally.
Ajuste de temperatura / Temperature setting
Para ajustar la temperatura de salida del agua, deberá actuar sobre la maneta mezcladora
situada a la derecha del grifo. El movimiento hacia delante (flecha roja) aumentará la
temperatura, y el movimiento hacia atrás (flecha azul) la disminuirá.
To adjust the outlet temperature of the water, you must act on the mixing handle located to the
right of the tap. Forward movement (red arrow) will increase the temperature, and backward
movement (blue arrow) will decrease it.
PRECAUCIÓN: Antes de realizar el montaje o mantenimiento asegurese de que los
elementos de corte (válvula de escuadra o llave de paso) están en posicion de CERRADO
para evitar inundaciones y que las conexiones y las tuberias estén limpias, ya que la
presencia de particulas extrañas en los conductos podrían inutilizar la electroválvula.
Al finalizar la instalación y antes de poner el grifo en marcha quitar el protector del sensor.
CAUTION: Before mounting or maintenance, make sure that the closing elements (angle
valve or stopcock) are in the CLOSED position to avoid flooding and that the connections
and pipes are clean, as the presence of strange particles in the pipes they could make the
solenoid valve unusable.
At the end of the installation and before turn on the tap, remove the sensor protector.
FUNCIONAMIENTO / OPERATION
INSTRUCCIONES DE MONTAJE
ASSEMBLY INSTRUCTIONS

Publicidad

loading