Brita WHS-202 Instrucciones De Instalación página 8

household filtration
Test the Filter
• Turn valve lever on housing head to
"off" position.
• Turn on water supply.
• Slowly turn valve on housing head to
"FILTER" position. The red indicator
should line up with "FILTER" on
housing head.
• Check for leaks.
• Turn on the nearest faucet and flush
for 40 minutes.
8
Step 4
WATER
OFF
*
BYPASS
*
*
*
FILTER
(WATER ON)
*
*
*
*
*
*
*
*
» If leaks continue, turn off the water supply and call
Customer Service or your local plumber.
household filtration
Troubleshooting
Guide
Leaks between
head assembly and
filter housing
Note: Place paper towels or rag under the filter
to catch any water drips.
Turn valve lever on the housing head to "OFF"
or "BYPASS" position.
Unscrew and remove the sump part from the
head part using the filter housing wrench.
Remove black o-ring and inspect. Clean and
lubricate with silicone grease.
Clean grooves in top of filter housing where the
o-ring sits.
Place the clean, lubricated o-ring back in the
groove.
Screw filter housing back onto the housing
head and hand-tighten.
DO NOT OVERTIGHTEN.
Turn the valve lever on the head to the
"ON" position and inspect for leaks.
Leaks around fittings
Turn off the household water supply.
Purge water from water lines by turning on
all faucets in your home and draining completely.
Tighten all fittings.
Turn on the household water supply, and turn
the valve lever on the housing head to the "ON"
position and inspect for leaks.
If leaks continue, disassemble the configured
unit, reapply plumber's tape or sealant, and
reinstall the filter.