Stihl HT 100 Manual De Instrucciones página 25

While holding the cap depressed,
N
turn it clockwise until it engages in
position.
The marks on the filler cap and oil tank
are then in alignment.
Fold the grip down.
N
HT 100, HT 101, HT 130, HT 131
Filler cap is locked.
If the oil level in the tank does not go
down, the reason may be a fault in the oil
supply system: Check chain lubrication,
clean the oilways, contact your dealer
for assistance if necessary STIHL
recommends that you have servicing
and repair work carried out exclusively
by an authorized STIHL servicing
dealer.
If the filler cap cannot be locked in the oil
tank opening
Bottom of cap is twisted in relation to
top.
Remove the cap from the oil tank
N
and check it from above.
1
Left: Bottom of cap is twisted –
inner mark (1) in line with
outer mark.
Right: Bottom of cap in correct posi-
tion – inner mark is under the
grip. It is not in line with the
outer mark.
Place the cap on the opening and
N
rotate it counterclockwise until it
engages the filler neck.
Continue rotating the cap
N
counterclockwise (about a quarter
turn) – this causes the bottom of the
cap to be turned to the correct
position.
Turn the cap clockwise and lock it in
N
position – see section on "Closing".
English
23