Taking Care Of The Guide Bar; Cleaning The Air Filter - Stihl HT 100 Manual De Instrucciones

English

Taking Care of the Guide Bar

2
1
Turn the bar over – every time you
N
sharpen the chain and every time
you replace the chain – this helps
avoid one-sided wear, especially at
the nose and underside of the bar.
Regularly clean the oil inlet hole (1),
N
the oilway (2) and the bar
groove (3).
Measure the groove depth – with the
N
scale on the filing gauge (special
accessory) – in the area used most
for cutting.
30
Chain type
Picco
Rapid
Picco
If groove depth is less than specified:
Replace the guide bar.
N
The drive link tangs will otherwise
scrape along the bottom of the groove –
the cutters and tie straps will not ride on
the bar rails.
3
Chain pitch Minimum
groove
depth
3/8" P 0.20"
(5.0 mm)
1/4" 0.16"
(4.0 mm)
1/4" P 0.16"
(4.0 mm)

Cleaning the Air Filter

If there is a noticeable loss of engine
power
4
Turn the choke knob to g
N
Take out the screw (1) and remove
N
the filter cover (2).
Clean away loose dirt from around
N
the filter.
Grip the filter element (3) at the
N
cutout (arrow) in the filter
housing (4) and remove it.
Fit a new filter element. As a
N
temporary measure you can knock it
out on the palm of your hand or blow
it out with compressed air. Do not
wash.
Replace damaged parts.
N
Installing the filter
Install the filter element in the filter
N
housing and fit the cover.
Insert the screw and tighten it down
N
firmly.
HT 100, HT 101, HT 130, HT 131
1
2