Descargar Imprimir esta página

Kohler K-4709 Guia De Instalacion página 9

Ocultar thumbs Ver también para K-4709:

Publicidad

Idiomas disponibles

Idiomas disponibles

Remote Holder
Anchors
6. Install the Remote Holder
Choose a mounting location for the remote holder that is easily
accessible while sitting on the seat.
The remote holder can be installed using screws or double-sided
tape. Choose your preferred method for securing the remote
holder. Follow only the instructions for your chosen installation
method.
Install Using Screws
NOTE: Anchors may not be needed for installation to certain
materials. Use the appropriate mounting hardware for your
particular installation surface.
Position the remote holder at the desired mounting location with
the rectangular indent toward the bottom (as shown).
Using a pencil, mark the two mounting hole locations. Set the
holder aside.
For installation to stud or other wood surface: Drill a 1/16" hole
at each of the marked locations.
For installation using wall anchors: Drill a 1/4" hole at each of
the marked locations. Install the wall anchors into the holes.
Position the remote holder over the mounting holes so the
rectangular indent is toward the bottom.
Secure the remote holder with the screws.
Kohler Co.
If used, apply tape here.
Screws
R E
T
O N
F R
L S
P U
E
A T
L L
C I
O S
O P
S T
N O
R W
F O
L E
D
Z Z
A R
N O
W
C K
B A
E R
I Z
O R
O D
D E
A T
S E
Covers
P .
M
T E
H 2
O
S P
A I
R
P .
T E
M
R
A I
9
A R
Remote
E
A T
L E
Z Z
D
A R
P .
T E
M
D
E E
1054180-2-E

Publicidad

loading