Bluetooth - Mobile Phone; Receive A Call - JVC KD-X372BT Manual De Instrucciones

Bluetooth®
• This unit supports Secure Simple Pairing (SSP).
• Up to five devices can be registered (paired) in total.
• Once the pairing is completed, the Bluetooth device will remain registered
in the unit even if you reset the unit. To delete the paired device, see
[DEVICE DELETE] on page 17.
• A maximum of two Bluetooth phones and one Bluetooth audio device can
be connected at any time. To connect or disconnect the registered device,
see [PHONE SELECT] or [AUDIO SELECT] in [BT MODE]. (Page 17)
However, while in BT AUDIO source, you can connect to five Bluetooth
audio devices and switch between these five devices. (Page 18)
• Some Bluetooth devices may not automatically connect to the unit after
pairing. Connect the device to the unit manually.
• When the battery of the connected Bluetooth device runs low, "Device
Name" "LOW BATTERY" appears.
• Refer to the instruction manual of the Bluetooth device for more
information.
Auto Pairing
(for KD-X372BT)
When you connect iPhone/iPod touch to the USB input terminal, pairing
request (via Bluetooth) is automatically activated if [AUTO PAIRING] is set to
[ON]. (Page 17)
Press the volume knob to pair once you have confirmed the device name.
14
ENGLISH
Bluetooth — Mobile phone

Receive a call

When there is an incoming call:
• The buttons will blink in the blinking pattern you have selected in
[RING ILLUMI]. (Page 15)
• The unit answers the call automatically if [AUTO ANSWER] is set to a selected
time. (Page 15)
During a call:
• The buttons stop blinking.
• If you turn off the unit or detach the faceplate, Bluetooth is disconnected.
The following operations may differ or be unavailable depending on the
connected phone.
To On the faceplate
First incoming call...
Answer a call
Press
Reject a call
Press and hold
End a call
Press and hold
or the volume knob.
or the volume knob.
or the volume knob.